A continuous fill level during operation of a combine harvester gives valuable information to coordinate with the drivers in the logistics chain. This helps to coordinate the tractor-trailer units when and which combine harvester to unload next.​

​The Baumer U750 ultrasonic fill level is the technology of choice for a robust, non-contact measurement of granular media. The design is tested to the highest off-highway standards, has a heavy duty connector and can be mounted easily on its flat back-side.

The Baumer oil level switch prevents damages caused by low fluid levels. Baumer brings capacitive frequency sweep technology to the off-highway industry. The CFAK 22 is superior to established technologies, such as float switches, fixed frequency capacitive and electro-optical level sensors. It is factory pre-set for hydraulic fluids and other operating fluids with similar properties such as transmission oil, diesel, etc.​

​It can be used for unpressurized fluid monitoring in e.g. differential cases, gear boxes, fluid tanks and for leakage detection.

Knowing the correct boom angle or roll of the boom allows for optimized boom stabilization and  control of the ground distance.

The Baumer dynamic inclination sensor delivers high measurement accuracy in dynamic applications to allow for higher productivity through increased speed. It is equipped with CAN output tailored to off-highway.

Knowing the center rack height relative to the frame may be an important information for the overall boom height control. Baumer Ultrasonic sensors offer a robust and reliable distance measurement. Alternatively a R600V sensor can be mounted to measure distance to the ground and crop.

Automatically controlling the distance between sprayer nozzles and crop relieves the operator and allows for better equipment utilization and higher speed.

The Baumer ground & crop radar sensor is key to modern boom height control, with its dual ground and crop distance output. Baumer radar signal processing delivers superior crop penetration and ground detection. The R600V allows for an easy design-in due to full industry compliance and its proven signal processing.

For many tools and implements such as tillage equipment, but also pavement marking, and weed removal the tool angle is important to precisely position the tool. Baumer angle sensors provide this feedback reliably and allow for precise control of work processes.

The compact, magnetic bearing-less encoder allows for an easy integration, lower total system cost, and reliable operation under high load conditions.